2. Position the appliance in the rack. 3. Install the appliance into the rack. Use all of the provided screws in both vertical rails of the rack. Caution: To prevent unstable mounting of the appliance, Hewlett-Packard recommends using two screws per bracket. 4. Now the cables should be connected.
Cable Connections
Use the following steps to connect the cables:
1. DB-9 Serial Port (supports all APC uninterruptible power supplies with a Simple Signaling cable (APC part # 940-0020B)) 2. RJ-45 Network Jack 3. Power Receptacle 1. Connect a twisted pair network cable (not included) with an RJ-45 connector to the RJ-45 jack on the back of the appliance (see Figure 1, number 2). 2. Connect the other end of the network cable to a network port. 3. If using an APC uninterruptible power supply (UPS), connect a Simple Signaling cable from the UPS to the DB-9 serial port on the back of the appliance. Note: The Simple Signaling cable is not included with the appliance or with the APC UPS. This cable can be ordered from APC (APC part # 940-0020B). 4. Connect the power cable to the power receptacle on the back of the appliance. Note: Make certain that air flow is not restricted around the back of the unit. 5. Connect the other end of the power cable to a power source. If a UPS is being used, connect the power cable to the UPS.
http://albatross.rose.hp.com/~lindsay/pdfs/english/hwinst.htm (2 of 3) [6/22/2001 11:25:49 AM]
